Hello all.
I am using an X-Controller and a 1000,1000mm machine.
My homing cycle works great. At least that’s what I think. After pressing home the machine goes home and the console returns an ok without errors.
My machine values read at: -789, -789, -1 while at home. (is the -1 correct?)
Before starting a job, I go to the zero in the stock and set my work zero values. This is done after homing.
Then when I start a job, the machine moves to the correct start position (not work zero but where the first carve will be done) and the Z axis goes up… and up beyond the homing position!!! it cracks for a bit and then starts the carve…
But of course the work zero values for Z are off. Way off.
Any ideas what I am doing wrong or what is wrongly configured?