Tried using my z probe for the first time today and was pretty excited to do so since I have a 2-stage carve. went thru all the set-up steps for my project in “carve” and when it asked if I was using the z probe I went thru those steps. when the carve started, z moved down a bit x, y moved into position and then z went down and started carving air…
So at this point I figured I needed to set the unit up before a carve so I went into “set-up your machine” and went thru all the steps there, then went back to “carve”. Again, same thing happened.
It seems to me my machine is raising the bit too high after the probe contacts, much more it looks like than when you set z manually. Anyone have the same probs and how did you fix???
