I am sitting up my x carve through Easel but my x controller power light wont come on. The fan turns on, but not the light? Any help would be greatly appreciated!
1 Like
Check your Estop.
It needs to be fully disengaged (turn and pull up) and also check the quality of the crimp.
The LED turns on if you have the Estop on.
The fan turns on as long as the power supply is on.
2 Likes
Estop wasn’t engaged…DUH! Thank you so much!
1 Like
Had the same issue, same problem. This should be added to the instructions…to ensure that the estop isnt depressed. its hard to tell if youve never used one before.
Same here. I agree with adding to the instructions.
I have the same problem, except my X-Controller otherwise works just fine. There’s just no power light regardless of the position of the e-stop or the power switch. I’ve been ignoring this for a year, but was hoping this thread would address my problem. Alas…
Make sure your ribbon cable between the front panel and main board is fully secured. Sometimes you think it’s fully engaged but it’s actually not. It’s a very common problem.
Thanks Justin, I’ll take a look when I get back to the shop.
Haha we’ve all been there!
1 Like
Hey Justin, I looked and checked and pushed all the wires in carefully and firmly. Still no joy. Any other ideas?
Check the actual connectors as there have been a batch which were overtrumped actually severing the connection inside the plastic covering, effectively hiding it from plain sight. A continuity check would verify electrical connection.
He’s not talking about the Estop, he just has no power LED indicator.
@ChristopherDahle try swapping ends of the cable between the front and main boards.
Hi Justin, Hi Haldor, thanks to both of you for the ideas. I hauled the offending machine along with it’s older brother (Arduino and G-Shield controlled) home for the Thanksgiving break to give them an overhaul. Then I decided that I needed to configure a couple of old laptops to run the X-Carves under Linux so the X-Controller is on the back burner again.
Too Much Information —> I’ve only got 3 computers in my school shop and when two students run the X-Carves, the rest of them have to share one computer to do their design projects. If I can get these old laptops to run Easel and drive the X-Carves, I’ll free the other computers up for student CAD work.
Anyway I do appreciate the help and just because the problem is low priority doesn’t mean I don’t want to fix it.
Cheers