I was just trying to figure out what settings should I set to make stars for a American flag.
also I want to do a skim on my mdf but I don’t think I set it right. I have the 1000mx1000m.
for a 37" flag I use a 1/2" wide 90 degree V bit
Set the depth to .25
Custom settings
Feed .25
plunge .25
depth of cut .25
I cut my stars in one pass
1 Like
Thank you.
@AndreeKing. Here is a link to my video. You can look at how I put it together and see all the settings. That way you can create your own. Also I have a link in the video description to the project on the inventables project page. It is ready to carve. Hope this helps.
How to Create the Stars in Easel for the US Flag - YouTube
1 Like
Thank you for all the help. I realized that every one has their own settings and look that they are trying to achieve in their work. I think one video told me to set the stars at a 50 and they came out nice in the video but I tested out a few settings and found that a 40 gave me that clean shape look. I’m always looking to learn more.
Omg Sir, I’m so slow you have been helping me out a lot. I sent you a email from my company email. FirstClassFlagsCo, thank you for your help, I wanted to know do you think it could be the type of v-bit I’m using. It’s a 90degree but it was bought off of amazon. And I’m your video you mentioned that you had to make some adjustments that I don’t recall seeing. If I click on your project file would all adjustments be set already.
I believe I sent you a picture of my 90degree bit and what my stars look like.
@AndreeKing. The file in the description of the video is ready to carve. It is the exact same one the I use