VCarve 3D Roughing Question

X-Carve
1

Is there a way to switch from Climb Cut to Conventional for my 3D Roughing Pass carves on VCarve?

Doing a roughing pass cut now and noticed it is doing a Climb Cut causing some chatter, when looking in the roughing settings I don’t see any options to switch between the two.

image
image392×881 114 KB

3

Ahh, Ok… I will take a look at some stuff when its complete. Doing 0.10 inch at 50ipm into poplar board which I think should handle it so ill dig into if something has come loose.