Hello All,
I’m selling my upgraded Shapeoko 2. I have loved using this machine and ended up purchasing a much more expensive machine because this machine was such a good first cnc experience.
The machine’s cutting area is stock (~12"x12"x2.5").
It uses the GT2 belting with the aluminum pulleys
The power supply is a 24 volt 300 watt low noise meanwell power supply (model HRP-300-24 bought for ~$80.00 new) with 87% efficiency and has short circuit, overload, over voltage, and over temperature protections.
I used very nice Nema 23 Lin Engineering Stepper motors (173oz/in) on the x and y axis (Motors were ~$60 / motor shipped) and all motors (x,y,z) are wired in series to the Tiny G motion controller.
The z axis is upgraded with a Nema 23 motor from Inventables (140 oz/in), a 2:1 Belt Drive Upgrade and the acme lead screw from Improbable Construct.
I bought an e-stop and limit switches and never got around to using them so I am including those for free.
There is also some extra shielded cable, screws, and wire management pieces.
Best of all, I have all the original packing materials that I meticulously saved from when I received the machine. So you will be getting a partly assembled and genlty machine that is packed in the original packing material (more packing material added where needed).
Pictures!:
I’m asking $600 for the whole machine with the extras mentioned, shipping from Louisiana, USA will be additional.