Hi there,
When I initially set up my x carve - i ran the setup through Easel and everything worked great aside from a mis aligned Y axis. Since then, i copied the recommended settings into Universal G-code sender.
This is a copy of my parameters:
$0=10 (step pulse, usec)
$1=255 (step idle delay, msec)
$2=0 (step port invert mask:00000000)
$3=0 (dir port invert mask:00000110)
$4=0 (step enable invert, bool)
$5=0 (limit pins invert, bool)
$6=0 (probe pin invert, bool)
$10=0 (status report mask:00000000)
$11=0.010 (junction deviation, mm)
$12=0.002 (arc tolerance, mm)
$13=0 (report inches, bool)
$20=0 (soft limits, bool)
$21=1 (hard limits, bool)
$22=1 (homing cycle, bool)
$23=0 (homing dir invert mask:00000011)
$24=25.000 (homing feed, mm/min)
$25=50.000 (homing seek, mm/min)
$26=25 (homing debounce, msec)
$27=3.000 (homing pull-off, mm)
$100=40.000 (x, step/mm)
$101=40.000 (y, step/mm)
$102=188.976 (z, step/mm)
$110=100.000 (x max rate, mm/min)
$111=100.000 (y max rate, mm/min)
$112=50.000 (z max rate, mm/min)
$120=10.000 (x accel, mm/sec^2)
$121=10.000 (y accel, mm/sec^2)
$122=10.000 (z accel, mm/sec^2)
$130=790.000 (x max travel, mm)
$131=790.000 (y max travel, mm)
$132=200.000 (z max travel, mm)
Now everytime i load up any gcode software, the machine is in alarm mode which i have to override each time. Now when i jog the machine the movement is so incredibly slow. I have no idea what i’ve done and why all of a sudden its so slow and is always in alarm mode. Can anyone help out? It’s very much over my head.
Edit: I mean slow like, hard to tell its moving slow.
