I drew a rectangle in Easel to check the calibration of my SO2. I’ve run calibration tests a couple of different ways, but an item I was trying to cut using other software came out a tiny bit small. To check, I ran the rectangle from Easel and I got exactly the measurements I should. But, I’m curious about why Easel set up the toolpath the way it did. My rectangle starts near the 0,0 mark, but the toolpath took the spindle all the way to the far corner (4",14.5") to start and end the cut.
Here’s my drawing:
http://easel.inventables.com/projects/CfEKZXoD0Espki0O-OXP1Q