I’m still getting the machine dilaled in. i just finished the build last night and was trying to get a good smooth movement out of it when i noticed the defauld travel was set at 1.25mm per rev so it was flying all around.
I just got a used machine that has a TinyG V8 controller. I am new to this, so I am not sure what to do as far as setup and configuration. Any help is appreciated!
THANK YOU FOR THIS POST! I guess I pushed the wrong button in Chillipepper or updating the firmware nuked all of the settings. My machine was DEAD. Now by using the data here, I got it back online. I have some weirdness with the Y Axis where the gantry shifts when the motors power down after a 100 or longer run.