Can I stop my carving and resume tomorrow?? If so HOW
What software are you using?
In Easel I think you can just hit the pause button.
I am using Easel. That’s what I just did. If it completes the job tomorrow i will post it. Thank you
Hit PAUSE, leave all electronics ON / Spindle OFF, turn spindle back ON and click RESUME when ready 
I usually take note of the XYZ- position in case something for whatever reason reset during the PAUSE period. (unless I have a fixed reference point)
Make sure that you do these steps in order or you’ll break a bit or damage your work.
Ask me how I know 
3 Likes
Broken bits and ruined work 
Smartass
LoL
1 Like