Hi,
Testing my new X-Carve, X and Y axis are moving too far.
I ran Easel setup config 4 times, always same result.
My setup is: 500 x 500 X-carve, ACME rod, Arduino Uno R2 grlb 0.9i, (tried 0.9j with same results) uploaded with latest Arduino IDE (I’m experienced in programing arduinos ).
In chillipeper, moving 1mm moves 5-6mm.
I guess it’s a steps/mm issue.
My gShield had only one jumper intalled when I received it. They were (and are still) set to
Z=2x
X=8x
Y=8x
Can anyone tell me what sould be the microsteping jumper setting and software steps/mm?
$$ in chillipeper gives:
Grbl 0.9i [’$’ for help]
$$
$0=10 (step pulse, usec)
$1=25 (step idle delay, msec)
$2=0 (step port invert mask:00000000)
$3=3 (dir port invert mask:00000011)
$4=0 (step enable invert, bool)
$5=0 (limit pins invert, bool)
$6=0 (probe pin invert, bool)
$10=3 (status report mask:00000011)
$11=0.010 (junction deviation, mm)
$12=0.002 (arc tolerance, mm)
$13=0 (report inches, bool)
$20=0 (soft limits, bool)
$21=0 (hard limits, bool)
$22=1 (homing cycle, bool)
$23=3 (homing dir invert mask:00000011)
$24=25.000 (homing feed, mm/min)
$25=500.000 (homing seek, mm/min)
$26=250 (homing debounce, msec)
$27=1.000 (homing pull-off, mm)
$100=250.000 (x, step/mm)
$101=250.000 (y, step/mm)
$102=188.976 (z, step/mm)
$110=500.000 (x max rate, mm/min)
$111=500.000 (y max rate, mm/min)
$112=500.000 (z max rate, mm/min)
$120=40.000 (x accel, mm/sec^2)
$121=40.000 (y accel, mm/sec^2)
$122=40.000 (z accel, mm/sec^2)
$130=290.000 (x max travel, mm)
$131=290.000 (y max travel, mm)
$132=200.000 (z max travel, mm)
$X
Thanks.