Solidcam easel

1

Hello everyone.
Do I have a question, when I do the gcode on solidcam, which machine do I choose to be compatible with easel?
thank you very much to all

2

If you can add your own post processor you could model it after one of these:

https://inventables.desk.com/customer/en/portal/articles/2933732-add-easel-s-post-processor-to-your-vectric-software

We also publish the Easel gcode spec
https://inventables.desk.com/customer/portal/articles/2258567-easel-g-code-spec

If Fanuc gcode is listed you can also try that.

3

Hi zach.
Thank you very much for answering.
I will deal with fanuc.
I can not install post processor.
Then I publish if it goes well with fanuc.