Shapeoko 2 -> X-Carve 2015 upgrade : Z-Probe mount

X-Carve Upgrades
1

Some carriages that were shipped for the X-Carve upgrade lack a hole for the Z-Probe. That was a bit annoying, so I whipped one up that you can use in combination with a couple parts from Amazon.com to get a nice looking Z-Probe port on the X Carriage.

The original file is here on Tinkercad, and I’ve attached the STL if you want to print one out. I recommend printing this with 2 perimeters, and 90% linear infill, using ABS or PETG for strength and flexibility ( PLA is a bit brittle for the task. )

https://www.tinkercad.com/things/28JzG8giaos-z-probe/editv2?sharecode=zZ-_Plrk9CDljdlwVKLlwUrWnbU1doT_EiIHJSnfoKY=

Z-Probe.stl (9.6 KB)

Amazon Parts:

http://a.co/dJ7dLs5 – Female sockets

http://a.co/6ur0r1E – Plug and leads

Screen Shot 2017-02-26 at 5.56.49 PM.png963×913 470 KB

3

Honestly, I don’t know. I’ve had a number of these upgrade boxes, and I finally opened this one. Two had the hole, two did not.