When I originally set up my X-Carve I said 'No" to homing/limit switches. I now have them. How do I tell Easel?
In Easel, open Machine Inspector and type $22=1 in the Console window, followed by pressing Enter.
Restart controller and homing is enabled.
You can also write $H +Enter in the same Console window to perform a homing cycle.
1 Like
Homing now works… It homes bottom left… Is there a way to home upper left? This would make preparing material.
Thanks for the info…
Skip…
Change $23=1 (it is probably 3 now)
Make sure your switch is there to stop the gantry!
2 Likes