Run Carvey without Easel

Carvey
1

I’m trying to cut some deep parts and there isn’t an option in Easel to cut an outer perimeter over one bit width, so I created gcode in JSCut, and manually added the carvey specific start/end code. It’s 30MB

I’m running off a Compute Stick (32-bit) so I can’t use Chilipeppr (too much memory used with my 30MB gcode)

I can’t load the gcode into Easel and run it because IE reloads the page, firefox is too slow, and chrome crashes.

I can’t use Universal Gcode Sender (worst name ever) because the hello message is gCarvin 1.1.5. ( Source code to gCarvin/grbl? - Carvey - Inventables Community Forum ran into other issues )

What should I do?

2

You may run into the same problem, but you could try the program below. If worst comes to worst the source code for this sender appears to be available.

http://zapmaker.org/projects/grbl-controller-3-0/ Download link is bad try here: