Well it sounded good. Easel moved past the COM port check but had no control over X,Y, or Z. I will keep at it…
I was able to get the compiling grbl to work and now have X,Y,Z control! so far so good.
1 Like
Hey Jeremy…did you ever figure out how to reflash the right grbl to the arduino? I can reflash w/ the Xloader but none of my XYZ green lights lit up and then when the g-code runs, the machine runs to the far left like the scale is off by ten times. This all started when i loaded grbl 8…to make it work w/ UGS…which it did, now I can’t reload 9i for x-carve to work right.
I did. I am not sure that I did the text book fashion of doing this, but I was able to recover the hex. I followed the details at:
Compiling Grbl · grbl/grbl Wiki · GitHub and Flashing Grbl to an Arduino · grbl/grbl Wiki · GitHub
I deleted my arduino software and reloaded it in one instance and then went through the process listed in the links above. In another instance, I was able to use Xloader to upload the hex found at:
There are some additional details at this string:
Hope this helps…likely too much info but this has been an interesting adventure for sure.
V/R
J.R.