Programmable Feedrate for Z up to safe?

Easel Feature Requests
1

I do a lot of detail carving where I am cutting lots of little pockets. The default feedrate for Z up to safety height seems to be F9.0. Is there a place I can go set that? There is no reason not to go F30 or so up out of a pocket. It would save some time in the big picture.

Yes… I can search/replace the Gcode before cutting. Just wondering if there is a way to tell easel to do it for me.

thanks.

2 Likes
2

I don’t use easel, but I think it is in advanced settings…safety height.

3

There is no asymmetric feedrate right now. Really the lift moves should be G0 rather than G1. That would allow them to be the faster seek rate by default.