No green light

X-Carve Troubleshooting
1

Assembled my new x-carve. No green light…fan is going. Already tried all the basic troubleshooting suggestions: disengage e-stop, make sure all wires are firmly connected, etc. Called Tech Support…they ran through troubleshooting…even had me bypass e-stop…still no light. They sent out a new upper control panel…STILL no green light! Anyone have any other suggestions. I’ll be calling Tech Support but thought if anyone had any ideas…

THANKS!

2

Assuming you’ve got the ribbon cables properly oriented, I’d say you’ve already covered the usual suspects.

Looks like a job for the Inventables support team.

3

I’d try flipping the ribbon cable orientation AND making sure it’s fully engaged. The clips will engage with the connector not fully seated.

4

Thanks…yeah had to call again…they sent me a new cable that runs from panel to panel and to the E-Stop. That did the trick!