Waiting on wiring components and spindle mounting plate. Until then just finishing up the folding table for the new Xcarve.
2 Likes
Looks good. You may also want to think about where you’ll place the power supply and electronics, as you’ll not want them sitting on the table top.
For mine, I put all the electronics into a sealed enclosure (it still has a cooling fan which pulls air through a foam filter) which is mounted to the side. The power supply is also mounted to the side, facing upwards allowing quick access to the power switch.
I’ll post some images if I can get to a PC…
1 Like
Just saw the photo…what a little ripper…(that’s great in Aussie) Also like the idea of your connectors for the electronics. I’ll be copying your ideas on that.
Thanks
Mike Kaplan
@MikeKaplan Oddly enough, I too speak Oz (I’m in Perth, Western Australia).
It’s possibly a little overbuilt, but it’s pretty robust. All the cables are clipped against the table so there’s nothing pulling on the connectors & the enclosure has a bunch of holes drilled in the back & covered with dust foam.
Everything is available from Jaycar or Altronics. The table I considered building, but instead I bought from Ikea (for basically what I’d have paid for the wood alone). It’s a 1200x1200x950H “bar” table, to which I added a few drawers, trays and fitted with locking wheels.
We’re not fancy, but we’re cheap…
1 Like
can you please give us a link to the ikea table and some pics? that would be super helpful so some of us could do the same.
hello… i want to ask
my bed test use dial indicator
flatness of about 0.3mm, is less than flat?
sory bad english
Thanks for your suggestion and pics for the power supply mount. I borrowed some of your ideas.
Mike
I have not received my X Carve yet but thru this table together out of material I had laying around. Cost $0
counting the days to get my machine. cant wait to get started.
That’s a great looking table!