I thought would I share the Clamp Holder that I made. I’m quite happy with the end result and put to use some of the things I learnt here like the recessed painting and sanding method.
The bolts holding the clamps are M5 Screws that I ground down so that I could quick release and lock the clamps with a half turn of the bolt. On the back are some of the tee nuts that I had spare that where going to be used on my wasteboard.
I did not take any photos during the creation process so I will just include an easel link rather than posting a project page.
So if you would like to make one the link is below.
