So in the very near future I’m going to have to transport my 1000x1000 X-Carve to a new house and wanted to know if anyone had some tips in doing so.
There shouldn’t be any issue with fitting it in a car for me, but I was a little concerned about the gantry’s sliding around during the drive and while tipping through doors, etc. What would you suggest to secure/tie it to avoid movement. I’d prefer to keep it in tact after putting all that time into assembly not too long ago.
Something as simple as zip ties would seem to work.
Yep…zip ties…bungee cords…duct tape…
Wire, string, bubblegum,
er, scratch the last one.
Clamps on the rails to stop movement of the gantry might do the trick.
One thing I would be careful of if I were moving the machine is to not torque or warp the machine too much in the moving process. The more square you can keep it the less you will need to do when setting it back up. Either way, you will want to step back through re-tuning your machine once it is in it’s final spot… eg. re-square, re-check tension on belts, if tension changes on the belts then re-check steps per mm… etc.
The times I have moved mine, I used scraps of 1x2 cut to length to keep the gantry from moving around, and just wrapped those in masking tape so they stay put. A piece of 1x2 fits just about perfectly in the flat spot on the side of makerslide, so you don’t have the end of clamps and stuff hanging off the sides or anything, and between the 1x2s being wood and using painters tape to hold them in place it was easily reversible and didn’t do any damage to the machine itself during moving.
Sounds like a good idea. But as it stands at the moment I don’t have too much scrap wood. The only thing I have in enough supply currently is various pink insulation foam. That should probably do the trick, no?
That should be OK, too, unless you’re REALLY banging the machine around. But if not, an 8 foot 1x2 furring strip at the home store is what, like $4? Maybe less?
Nah, it should sit nice and flat in the Mrs’ suv and almost all highway between the two places.
Put a couple spring clips on the maker slide
I just moved my unit from inside my house to a new bench I built in the garage. I put zip ties on both sides of each stepper motor assembly, around the extrusion and right next to each pulley and idler. No movement at all on either axis. It’s simple, and I think this would work even for a drive, although with a drive and the bumpin’ and jumpin’ you might get, I would recheck square on everything once you’re set at your new location. Keddy
