Learning me bits

1

So I am using a 60 degree vbit on my first largish test run. I’m using MDF but its coming out pretty good and am wondering a few things:

I know the vbits will leave sort of a stroke as they don’t cut straight down as they are v shaped. Is there a 2nd pass bit I could use to simply remove the stroke and make it vertically straight? Would a 90 degree vbit cause less of a stroke? Here is a video … 20180223 212108 - YouTube

On MDF - Cuts easy but it also damages easy, corners etc. What would anyone recommend to help preserve it, toughen it up, etc?

Thanks!

2

If you don’t want the angle from the V bit, use a down cut end mill the size appropriate for your project instead

3

Easel only shows up cut for some reason.

4

Functionally the same on the generate detailed preview?

5

Yes, You can select the up cut and should be good to go.

6

It is preferable to measure your bit, or cut a straight line and measure the width of the cut and use that measurement in the ‘Other’ box.

7

I use up cut bits with MDF with good results as well.