I assume this stuff is tricky to work with since its Aluminium over top of a composite plastic material.
I looked on the forum here and found some cool looking projects done with it…
is this stuff going to kill my spindle?
The spindle can handle it check out https://www.toolstoday.com/ for bits. If your worried about it you can always just send it to me!
1 Like
I rout ACM “dibond” at work at least a few time a week. It routs pretty easily. Never tried it on my X-CARVE. You can ignore the aluminum. It’s only few thousandths of an inch. So really it’s just a soft plastic, so single flute spiral up cut bit 12000 rpm, 75-125ipm. I can cut an 1/8 inch sheet in one pass on my machine at work. I suggest you be more conservative. Side note: check out ACM folding bits you can do some pretty cool stuff with bending and forming.
2 Likes
If your near Pittsburgh I can direct you to a dumpster filled with dibond, PVC, and acrylic.
2 Likes
I live near Greensburg. I could go for some free acrylic and pvc. What kind of acrylic? Cast?
1 Like
so before I read this…I decided to cowboy the whole thing…I clamped it down and used a 60 vbit
this stuff is damn cool…I’m in love…shhhh dont tell my wife but I may leave her for this stuff lol
2 Likes
Great information, THANKS!
1 Like