When carving a project I setup the bit off the project material when I go to start at one point the router is raised when I turn on the router and start carving. When complete it returns back to the start point is there a way to know how high the router is so that I can have it go back down and run over the project to clean it up. If I just go thru the standard process of carve when I get to the router it will just raise higher thinking it’s at it’s zero point. I know if I shut off the power supply and lower to the zero point like the first time I my not hit it like the first time.
It should be at your safe height, set in Easel.
To start the second run you will still need to set z axis
Just hit carve again and select the “use previous XY zero home point” option. It should do the exact same carve again, without having to reset your Z height again
2 Likes
Indeed, and you can also prior to the second carve jog the bit out of the way to insert new material without the need for a recalibration.
Note that Z will move to safety height before traversing back to XY0.
Aloha everyone
Thanks for the answers I’ll give it a try and see what happens.
Take a look at this video. This may help