Help needed please
I plan to cut a picture (a tiger) with very thin lines, how should I go do
Use V-bit only? Its pointy tip can carve thin lines.
I dont understand the 1/32" bit as first stage / V-bit as 2nd stage you have set up in your file.
Sorry I was confused when I tried to cut with 2 difference bits so I didn´t start.
That´s why I ask the question
Did U mean that I should use onle v-bits ?
@KristianAng. There is a lot to learn when you are first starting out. Take a look at some of my videos on Easel and the Xcarve. It should help you get going
Paw Paw’s WorkShop - YouTube
Good luck
Yes, if all you want to do is carve the design on a piece of wood.
Thx Philip
I will
HaldorLonningdal’s advice will get you through this project just fine. PhillipLunsford’s advice will help you beyond. Great advice from both.
3 Likes
I wonder what type of bit is best for the project 30 60 0r 90 deegre