GAH!!! Belt broke in mid carve… (insert many many many swear words here)
and before someone says it… nope, no back ups… 
1 Like
It must have happened when I upgraded the Y plates… grrrr
why would the Y plates cause a belt to break?
I have Charlie’s plates and have no problems.
Sorry… not what I meant. When I replaced the plates, I likely overlooked the placement of the belts… not suggesting it was the fault of the plates. I merely meant that when I loosened and tightened the belts, I likely caused something…
Does anyone know if this will replace?
I will throw caution into the wind and give it a whirl.
I know they work and they feel beefier since it’s the 3rd gen of the product.
Oh wait, you’re Canadian…ummm search for a Canadian supplier of that part number?
1 Like
Thanks all… will order the ones above and see what happens…
Always something, eh… 
Reading up on that very thing right now …
Next on my list … thanks
1 Like
You could always consider the screw drive conversion kit that another guy put together; gets rid of belts for good.
What?? No pics?
You know, misery likes company! 
Is it near an edge? If so, tape it up and flip it and avoid that area.
If it’s in the middle then well…
2 Likes