I have seen a few share the same type of issue. I am stuck on simulating toolpaths.
Is this just a time related issue or is there other problems? Also, if we simulate toolpaths first and then go through the setup process will that fix the issue? I really don’t want to have the machine on for too long.
Your project has not been shared publicly, so we cannot view it
Shared now
or
Not sure what link will do the job.
I’ve seen this issue with SVG’s that I’ve tried to import that have a large number of objects, and it looks like yours is in that same category. you have a massive number of small objects and I dont think that Easel can properly handle this many.
I’d suggest either simplifying the source to have fewer small segments, or copy the project to multiple pages and remove objects until you can get the simulate to run but then you will need to run each page independently.
But honestly looking more closely you really need to remove the ‘noise’ in this work you have multiple redundant paths and small traces that add nothing to the pattern.
Just my $.02
Mike
I’d say its a bit complex for Easel. Definitely will need some cleanup.
I am having the same issue, but only if I try to simulate toolpaths for a v bit. It goes through fine with a 1/8 and then again if i add a detail pass. But it will not go through with v bit.
