I have been using my X-Carve, for a little more than a year. It use to lock for tool changes, but I had a problem and had to replace my control boards. Now I can not lock the stepper motors during tool change.
I understand I can change GRBL to $1=255. My question is, do I go to Machine in Easel, then advance, and that’s where I am not sure where from there. I have never made any changes on my machine and don’t want to mess it up. I also use V-Carve and Aspire for most of my work if that matters.
Thanks in advance for any help.
Machine–>Advanced–>Machine Inspector
In the console, when connected to the machine, type $1 = 255
That’s it.
Oh, and you also want to set the #4 dip switch on each axis to off.
1 Like
Thank you. I thought that was how but wanted to be sure.
1 Like