We use cookies to personalize content, interact with our analytics companies, advertising networks and cooperatives, and demographic companies, provide social media features, and to analyze our traffic. Our social media, advertising and analytics partners may combine it with other information that you’ve provided to them or that they’ve collected from your use of their services. Learn more.
So far I’m liking the new x-controller. I felt it has more power compare to stock andruino/grbl shield. Usually on my old controller after few cuts on carbon fiber, it start showing some slight curving on straight line and I need to replace new sharper bit. But with the x-controller, I’ve been cutting couple of sheets now on same bit and the cut quality are still good.
Also the build pause/resume is freaking excellent. I use it couple of times to remove some big pieces that was suck on my dust shoe. Built-in emergency stop and much nicer port wiring.
By the way I’m still using single Y axis connectint cause it’s the most easiest route without rewiring my xcarve. I just simple put the pot to the highest value for Y axis.
The following upgrade done on my xcarve
Makita Compact Router (Lowes)
X-Carve DeWalt 611 Spindle Mount with 3D Printed Ring Spacers and Air Deflector
May I ask you a question about installing the new controller. When I first turned it on computer recognized a new device. To install the new driver, do u install it under the arduino file?
Well I got it going. Had to install new driver under arduino folder. Changed my com port as well. I like your set up by the way. Been thinking of doing a vacuum port similar to that
What kind of spindle are you using and how are you controlling it automatically? A relay of some sort?
Also, what software are you controlling the X-Carve with?
If you’re cutting carbon, you should check out Dragon Plates. They sell the highest quality carbon, and you can select carbon specific to your needs. They sell quasi-isotropic carbon which is much stiffer and strong than standard carbon fiber.
