I may be over looking something here but here is what i am trying to figure out to do.
Draw about 1/4 inch thickness rings about 3 inches in diameter out of wood.
Then be able to cut the same out in a piece of wood to be able to inlay that ring i already cut out into the recessed ring i cut out in the wood already. am i missing something?
If I understand you correctly you can do that. What problem are you running into?
When i create a circle within a circle to create the ring i want to cut out how do i tell it what thickness to cut the ring out at as well as how to i tell it what thickness to cut the inlay so that they match.
Go to the “shape” menu on the floating tool bar. You can adjust the diameter of the circle there. On the cut menu you want to chose outline. The diameter of the bit will determine the thickness of the cut line.
