Our new XCarve with controller upgrade started smoking today. We took the controller apart and found that the circuit board was burnt. Anyone else have this problem?
you could replace the burnt circuit TB6600HG
Contact Inventables customer success.
2 Likes
If you attempt to replace that chip it may jsut burn out again.
You need to determine the cause.
I would start checking the power lines and connections for shorts.
Then once you have figured out the error. Then get a new X controller.
Repair requires you to check everything on that circuit. If you have good tech skills and a schematic you can do that. Otherwise its not worth the frustration.
Hi there. Just burned mine. 
How did you solved your problem?
Thx
Did you move the gantry by hand? That’s how I burned mine.
Yep, that’s what I was just going to ask.