So I went through the machine… I think! Belts are at about 5lbs, all wheels are rolling, cleaned everything up, squared the z. But yet the circle “outlines” are thin in spots and thicker in others. Design issue, or machine?
What cutter? Feed rate? Depth of cut? And how wide is the slot?
35 inches
.035 depth
Slot depth 1/4 about 1/8 wide
Haha! No. How do u do that?
X controller
No!
thanks a lot phil! never realized I had to do that.
already been watching videos!
1 Like
It’s also best not to make the slot the diameter of your cutter. Oversize just a smidge.
1 Like