Carving unevenly

X-Carve Troubleshooting
1

For some reason, when carving in the Y+ direction, my X-Carve cuts deeper than the other directions. The endmill makes a sort of chattering noise, and digs in. This only happens in that direction. It seems to get more pronounced with greater speed or DOC.

with a 1/4" endmill, at 50 IPM, and .08 DOC. It is really pronounced. At .04 DOC it is much less noticeable, but still there.

Ive checked everything for square, and as far as I can tell, the endmill rides square to the surface. I’ll have to check it again when I get out there tomorrow, but I couldn’t find anything loose or out of line.

Has anyone else had this happen?

3

First check that you waste board is perfectly level thats usually the issue, if not check that your y axis is level (use a level don’t do it by eye

1 Like
4

I have a piece of wood on top of my waste board that I have milled flat and true to both the X and Y axes. That’s what I use as my base for mounting my work. That should be good, but I will have a look at it as well, thanks.

I hadn’t thought of the wheels on the end plates. I’ll have to look at that.

1 Like
5

I am having the same issue.
What I notice is that the y axis rails are not at the same height from the waste board.
what I plan on doing is getting a block cut to a specific height and use it to tighten the y end plates t-slot fasteners so its at a specific height for each end. This way the x gantry will be level across. When assembling it I did not have a level surface for putting it together. So I will have to use the block as a measurement device.

1 Like
6

My issue with it was due to the little bolt holder slide in pieces were not 100% centered in the rail. Made it so I was roughly 1/8th a inch off.

Micrometer from harbor freight solved my issue now it’s within a 32nd of a inch. Just mic everything. Mine was where the angle brackets on the one side was off by a 8th.

Made a huge improvement checking it.

Best of luck.

1 Like
7

What is the bold holder slide?
Where is that?
Can you take a photo please.

8

the little silver piece you slide into the extrusion part.

these things ^^^ they were offset on mine so it would allow for some slop when assembling (had no flat surface and was fun to find)

10

It’s how I did mine but it had slop in the channel. Allowed the plates to shift. Is the only input I can share in trying to get it square