Bit Holder made with the box app.
1/8th White PVC
8 Likes
Looks great! Nice job!
Thanks it was quick to cut out maybe 8 minutes
50 ipm
0.06 depth of cut
Pvc cuts like butter with the 1/16th bits
What bits do you use? I’m looking to expand my bit collection and would welcome some advice.
Used the 1/16th bits in the picture with the green band around them
Ordered from drillman1 on ebay
That’s a nice one. I like how it’s also inexpensive. Did you make a project? If so I’ll add it to the tools section.
@zach_kaplan
Will post up once I’m home tonight in this thread
Grant
1 Like
Hi Zach, see link below Im not sure if you need anything else?
Cut with 1/16th inch bit, 50ipm depth of cut per pass was 0.06"
0.120" PVC piece was 9"x7" cost of materials would have been less than $1.00
Holes are for 1/8" Shank Bits cut them at 0.130" to allow a little bit of wiggle room
Glued together with Crazy Glue
Anything else let me know
Grant
Hey Grant if you use the publish feature I can add it to the tools section.
@Zach_Kaplan Published!