Greeting,
I assembled the new X-crave .
Connect to Easel and test Z axis .
The Z axis motor only move very little in either directions.
Take the belt off the motor.
Test it again the Motor move normally.
I can hand turn the Z axis .
Is there any thing I need to adjust ?
Thank you
How much are you asking it to move? I job mine by the mm.
Hi Kc,
When i assembled mine… i also had slipping. The reason it was slipping for me was I didn’t tighten the pully enough…
Check to make sure that it is tight…
Thanks…I will check that tomorrow…its been a long night
did you skip the step of running the rod up and down manually ? also the top bolt that holds the spindle rotates the rod doesn’t need to be torq’d down it needs to be adjusted ever so slightly …
The motor will turn the spindle rod & move the holder up/down if I take the dewalt spindle out.
But once I put the Dewalt on then it won’t move
Yes it is X-controller
