Whats new:
Cutting area 30"x50"
Hall Effect Sensors (added cool lights?)
Spindle Relay
Steel Supports for the Y-axis (Still want to add more)
Wide Makerslide X
3d printed “suck it” dust shoe
Z Probe (ok its just a 1-2-3 block)
What is left to do:
Waste board for the entire build volume with T track
cnc4newbies Z slider (ordered yesterday)
Y dust guards
A version of Phils controller
Very excited! Ordered some of these parts a year ago, yay life!
Off to do some calibration!
yep, just ninja edited.
Had to get a little creative with the wiring as open builds version of the makerslide doesn’t allow for limit switch screws or terminal blocks.
Very nice upgrade, I barely have room for the 1000 x1000.
I put the xcarve in my basement, the rest of my tools are in the garage. Due to room issues 
I really wanted to do 1/4 sheet stock.
ROFL 1/4" sheet rock. My shop started as a 14’x 16’ shed 3 years ago. Since then I have already added 10’ by 16’ onto the front and have started adding 10’ x 26’ on the side. Still don’t think it will enough room.
